2. Under Main tab, select the profile you want
to activate.
3. A pop-up window appears “A Power Cycle is required to make settings activate properly.”
Tap OK, and then tap OK to exit the Summit Client Utility.
4. Tap Start → Programs → Utilities → Boot-Mode. Tap Warm Boot to warm start the
PDA Scanner and load the previous settings.
5. The Summit icon on the taskbar indicating
the AP is connected.
Double tap this icon to bring up Summit
Control Utility. Tap Disable Radio, you can
disconnect the AP.
Under Status tab, you can see the IP
address, signal strength and quality.
If you want to learn more detailed settings of the SUMMIT utility, please visite SUMMIT website
(http://www.summitdatacom.com/documentation.htm).
Bluetooth Connection
Your device is provided with Bluetooth wireless technology that you can use to synchronize
information with a computer equipped with a Bluetooth adapter or access point. Bluetooth
wireless technology allows you to communicate with the computer whenever it is within a
range.
You may use BTMAN, which will be described, to enable the Bluetooth module.
31