Unitech MS836 User Manual

Continuous Mode
Continuous Mode: A trigger press activates the
scanner to scan and decode at user-specified
intervals, i.e. the timeout between decodes. Each
decode session lasts until barcode is decoded or
the decode session timeout expires. To
suspend/resume the operation, simply press
the trigger. By default, the scanner rereads
same barcode with no delay.
Continuous Mode
W030002
Decode Session Timeout: This parameter sets the
maximum time decode session continues during a
scan attempt. It is programmable in 1s increments
from 1s to 255s. The default timeout is 15s. If the
parameter is set to 0, the decode session timeout is
infinite.
Decode Session Timeout
M00031D
Example: Set the decode session timeout to 5s
1. Scan the Enter Setup barcode.
2. Scan the Decode Session Timeout barcode.
3. S c a n t h e num e ri c b a r c od e “ 5 ”. ( S ee t h e D igi t
Barcodes section in Appendix)
4. Scan the Save barcode. (See the Save/Cancel
Barcodes section in Appendix)
5. Scan the Exit Setup barcode.

Unitech MS836 Specifications

General

Type	Handheld bar code reader
Wavelength	650 nm
Sensor type	Laser
Scanner type	1D
Read rate (max)	100 reads/s
Maximum scan area	220 x 250 mm
Maximum scan width	220 mm
Linear (1D) barcodes supported	Codabar, Code 128, Code 39, EAN-13, EAN-8, GS1-128 (UCC/EAN-128), Interleaved 2 of 5, MSI, U.P.C.
2D (matrix & stacked) barcodes supported	Not supported
Standard interfaces	USB
Connectivity technology	Wired
Power consumption	85 mA
Buzzer	Yes
Certification	CE, FCC
Product color	Black
Housing material	Plastic
International Protection (IP) code	IP42
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 45 °C
Operating relative humidity (H-H)	5 - 85 %

Weight and Dimensions

Depth	95 mm
Width	70 mm
Height	160 mm
Weight	150 g