EasyManuals Logo
Home>Unitech>Scanner>MS916

Unitech MS916 User Manual

Unitech MS916
117 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
vii
© 2015 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
Battery Notice
1. To guarantee optimal performance, it is recommended that rechargeable
batteries be replaced every year, or after 500 charging cycles are
completed. It is normal for the battery to balloon or expand after one year
or 500 cycles. Although it does not cause damage, it cannot be used again
and must be disposed of according to the location's safe battery disposal
procedures.
2. If a battery performance decreases more than 20%, the battery is at the
end of its life cycle. Stop use and ensure the battery is disposed of
properly.
3. The length of time that a battery lasts depends on the battery type and
how the device is used. Conserve the battery life by doing the following:
Avoid fully uncharging the battery because this places additional
strain on it. Several partial uncharges with frequent charges are better
than a fully uncharged battery. Charging a partially charged battery
does not cause harm to the unit.
Keep the battery cool. Avoid hot vehicles. For prolonged
storage, keep the battery at a 40% charge level.
Do not leave the battery uncharged and unused for an extended
period of time, the battery will wear out and the longevity of the
battery will be at least half of one with frequent charges.
4. Protect battery life by not over or under charging the battery.
5. Please do not leave battery unused for long time without charging it.
Despite unitech’s safety precautions, the battery pack may begin to
change shape. If so, stop using it immediately. Please check to see if you
are using a proper power adapter to charge the battery or contact your
service provider for service.
6. If you cannot charge the battery after it has been idle for an extended
period of time and it begins to heat up, please do not try to charge it. It
may not be functional anymore.
7. Please only use the original battery from unitech. Using a third party
battery can damage our products. Please note that when such damage
occurs, it is not covered by your warranty.

Other manuals for Unitech MS916

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Unitech MS916 and is the answer not in the manual?

Unitech MS916 Specifications

General IconGeneral
TypeHandheld bar code reader
Wavelength650 nm
Sensor typeLaser
Scanner type1D
Read rate (max)104 reads/s
Linear (1D) barcodes supportedCodabar, Code 128A, Code 32, Code 39, Code 93, EAN-13, EAN-8, MSI
2D (matrix & stacked) barcodes supportedNot supported
Bluetooth version2.1+EDR
Standard interfacesBluetooth, USB
Connectivity technologyWired & Wireless
CertificationCE, FCC, BSMI, VCCI
Keys quantity3 keys
Product colorWhite
Internal memory16 MB
Built-in displayYes
Housing material-
Display resolution128 x 64 pixels
Display technologyOLED
International Protection (IP) codeIP42
Battery capacity680 mAh
Power source typeBattery
Storage temperature (T-T)-30 - 70 °C
Operating temperature (T-T)0 - 50 °C
Harmonized System (HS) code84716070
Weight and Dimensions IconWeight and Dimensions
Depth95.9 mm
Width36.9 mm
Height21.1 mm
Weight63 g

Related product manuals