5756
Compliance information
Declaration of Conformity
Hereby Unitron declares that this Unitron product is in
compliance with the essential requirements of the Medical
Devices Directive 93/42/EEC as well as the Radio and
Telecommunications Terminal Equipment Directive 1999/5/EC.
The full text of the Declaration of Conformity can be obtained
from the manufacturer or the local Unitron representative
whose address can be taken from the list on www.unitron.com
(worldwide locations).
Notice 1:
This device complies with Part 15 of the FCC Rules and with RSS-
210 of Industry Canada. Operation is subject to the following two
conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, including
interference that may cause undesired operation.
Notice 2:
Changes or modications made to this device not expressly
approved by Unitron may void the FCC authorization to operate
this device.
Notice 3:
This device has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules
and ICES-003 of Industry Canada. These limits are designed to
provide reasonable protection against harmful interference in
a residential installation. This device generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this device
does cause harmful interference to radio or television reception,
which can be determined by turning the equipment o and on,
the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the device and receiver.
Connect the device into an outlet on a circuit dierent from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
Australia: Supplier Code Number N15398
New Zealand: Supplier Code Number Z1285
To Next Page
Loading...
Need help?
General
