2/3
I
DENTIFICATION OF GEARS
X
AND
Y:
Gear X has an engraving "Z41S", and gear Y has the one "Z40S-Z13S".
C
ONTENTS OF CHANGE
:
The following are changed to prevent gears X and Y from being attached to the wrong positions. By the way, their part
numbers remain unchanged with these changes.
Change-1: The exterior color of gear X is changed from white to black to prevent the wrong attachment.
Item A for CDC 1626, CDC 1726, CDC 5526, CDC 5626, CDC 5526L, CDC 5626L
DCC 2626, DCC 2726, DCC 6526, DCC 6626, DCC 6526L, DCC 6626L
260ci, 261ci, P-C2660MFP, P-C2665MFP, P-C2660iMFP, P-C2665iMFP
CLP 3721, CLP 3726 / CLP 4721, CLP 4726
P-C2160DN, P-C2660DN
Applicable parts GEAR Z41S (302KV02B70)
Change-2: A rib is applied to a part of the gear holder where it is near gear X. Accordingly, the fulcrum boss of gear Y
contacts the applied rib when gear Y is attached to the fulcrum shaft for gear X.
Item B for
P-C3061DN, P-C3560DN
Applicable parts HOLDER GEAR (302NS02230)
Item B for P-C3060MFP, P-C3065MFP, P-C3560iMFP, P-C3565iMFP
Applicable parts HOLDER GEAR (302NR02230)
D
ETAILS OF
C
HANGE
-2:
Gear X
Gear Y
Note: For item A, they become identifiable with the exterior color.
[Exterior color] New gear X Black
gear Y Whilte
Gears X and Y attached to each position after this change
Correct positions Wrong positions
Gear holder
(302NR02230 / 302NS02230)
The rib is applied
Gear Y
Gear X
Gear Y
Gear X
The clearance between the
applied rib of the gear holder
and the outer diameter of the
fulcrum boss of gear X is
about 0.9mm.
The applied rib of the gear
holder contacts the outer
diameter of the fulcrum boss
of gear Y that was attached to
where gear X is normally
attached.
To Next Page
Loading...
Need help?
General
