11-16
Appendix > Paper
Choosing the Appropriate Paper
This section describes guidelines for choosing paper.
Condition
Avoid using paper with bent corners or that is curled, dirty, or torn. Do not use paper that has a rough surface or paper
fiber lint, or that is especially delicate. Use of paper in any of these conditions will not only deliver poor copies but may
also cause jams and shorten the useful life of the machine. Choose paper with a smooth and even surface; however,
avoid coated paper or paper with a treated surface as it may damage the drum or fusing unit.
Ingredients
Do not use paper such as paper that has been coated or surface-treated or paper that contains plastic or carbon. Those
types of paper may produce harmful fumes from the heat of printing and may damage the drum.
Be sure to use the standard paper that contains at least 80% pulp, i.e., not more than 20% of the total paper content
consists of cotton or other fibers.
Supported Paper Sizes
Paper of the following sizes is supported by the machine.
Measurements in the table take into account a ±0.7 mm dimensional accuracy for length and width. Corner angles must
be 90° ± 0.2°.
Paper Size Cassette 1
(P-4030i MFP/P-4035i
MFP)
Cassette 1
(P-5035i MFP/P-6035i
MFP)
Cassettes 2
to 5
Multi
Purpose
Tray
Envelope Monarch (3-7/8 × 7-1/2") × ×
Envelope #10 (4-1/8 × 9-1/2") × ×
Envelope DL (110 × 220 mm) ×
Envelope C5 (162 × 229 mm)
Executive (7-1/4 × 10-1/2")
Letter
Legal
A4 (297 × 210 mm)
B5 (257 × 182 mm)
A5 (210 × 148 mm)
A6 (148 × 105 mm) × ×
B6 (182 × 128 mm) ×
Envelope #9 (3-7/8 × 8-7/8") × ×
Envelope #6 (3-5/8 × 6-1/2") × ×
ISO B5 (176 × 250 mm)
Hagaki (100 × 148 mm) × × ×
Oufuku hagaki (148 × 200 mm) ×
Oficio II
216 × 340 mm
16K (273 × 197 mm)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
