4-77
Operation Panel
DHCPv6 (DHCPv6 setting)
DHCPv6 is the next-generation of the Internet's Dynamic Host Configuration Protocol and supports IPv6. It extends the
BOOTP startup protocol that defines the protocols used for transferring configuration information to hosts on the network.
DHCPv6 permits the DHCP server to use its expanded functionality to send configuration parameters to an IPv6 node.
Because the network addresses that can be used are allocated automatically, the IPv6 node management workload is
reduced in systems where the administrator has to exercise close control over IP address allocation.
1 In the IPv6 Setting menu, press or to select DHCPv6.
2 Press [OK]. The DHCPv6 menu screen appears.
3 Press or to select DHCPv6.
4 Press [OK]. The DHCPv6 screen appears.
5 Press or to select whether DHCPv6 is enabled.
6 Press [OK]. The DHCPv6 setting is set and the IPv6 Setting
menu reappears.
LAN Interface (LAN Interface setting)
Specify the settings for the LAN interface to be used.
1 In the Wired Netwk. Set menu, press or to select LAN
Interface.
2 Press [OK]. The LAN Interface screen appears.
The available LAN Interface are as follows:
Auto
10BASE-Half
10BASE-Full
100BASE-Half
100BASE-Full
1000BASE-T
3 Press or to select the desired LAN Interface.
4 Press [OK]. The LAN Interface is set and the Wired Netwk. Set
menu reappears.
DHCPv6 Settings:
DHCPv6
01
IP Address
02
Note When On is set, IP addresses are shown in "IP
Address" after network restart.
LAN Interface:
Auto
01
10BASE-Half
02
*
10BASE-Full
03
To Next Page
Loading...
Need help?
General
