Preparation before Use
2-2
Changing Network Interface Parameters
This printer supports TCP/IP (IPv4), TCP/IP (IPv6), IPP, SSL Server and the IPSec protocols and Security Level.
The table below shows the items required for each of the settings.
Configure the printer's network parameters as appropriate for your PC and your network environment.
Menu Submenu Setting
Network Wired Netwk.
Set
TCP/IP
Settings
TCP/IP On/Off
IPv4 Setting DHCP On/Off
Auto-IP On/Off
IP Address IP address
Subnet Mask IP address
Default Gateway IP address
IPv6 Setting IPv6 Setting On/Off
Manual
Settings
IP Address IP Address
Prefix
Length
0-128
Default
Gateway
IP Address
RA(Stateless) On/Off
DHCPv6 On/Off
LAN Interface Auto/10BASE-Half/
10BASE-Full/
100BASE-Half/
100BASE-Full/
1000BASE-T
Protocol
Settings
Bonjour Off/On On/Off
IPSec Off/On On/Off
NetBEUI Off/On On/Off
SNMPv3 Off/On On/Off
FTP(Server) Off/On On/Off
SNMP Off/On On/Off
SMTP Off/On On/Off
POP3 Off/On On/Off
RAW Port Off/On On/Off
LPD Off/On On/Off
IPP Off/On On/Off
Port Number 1 - 32767
IPP Over SSL Off/On On/Off
To Next Page
Loading...
Need help?
General
