Utax P-5031DN User Manual

4-91
Operation Panel
IPSec (IPSec setting)
IPSec (IP Security Protocol) is a security protocol adopted as the standard by the IETF for authentication and encryption in
the third network layer (IP layer).
It can be used with both IPv4 and IPv6.
1 In the Basic menu, press  or  to select IPSec.
2 Press [OK]. The IPSec screen appears.
3 Press  or  to select whether IPSec is enabled.
4 Press [OK]. The IPSec setting is set and the Basic menu reappears.
LAN Interface (LAN Interface setting)
Specify the settings for the LAN interface to be used. The default setting is Auto.
1 In the Basic menu, press  or  to select LAN Interface.
2 Press [OK]. The LAN Interface screen appears.
The available LAN Interface are as follows:
Auto
10BASE-Half
10BASE-Full
100BASE-Half
100BASE-Full
1000BASE-T
3 Press  or  to select the desired LAN Interface.
4 Press [OK]. The LAN Interface is set and the Basic menu
reappears.
MACAddressFilter (MAC address filtering setting)
This sets whether or not to enable MAC address filtering.
1 In the Basic menu, press  or  to select MACAddressFilter.
2 Press [OK]. The MACAddressFilter screen appears.
3 Press  or  to select whether MAC address filtering is enabled.
Note IPv4 uses 32-bit IP addresses and IPv6 uses 128-bit IP addresses.
IPSec:
Off
01
On
02
*
Note LAN Interface is only displayed when the optional Network Interface Kit (IB-50) is installed.
LAN Interface:
Auto
01
10BASE-Half
02
*
10BASE-Full
03
Note The detailed settings for MAC address filtering are selected using the optional Network Interface Kit utility
software.
MACAddressFilter:
Off
01
On
02
*

Utax P-5031DN Specifications

General

Brand	Utax
Model	P-5031DN
Category	Printer
Language	English