Utax P-5031DN User Manual

2-5
Preparation before Use
14 Press [OK]. The DHCP screen appears.
15 Press  or  to select Off or On.
16 Press [OK]. The DHCP setting is set and the IPv4 Setting menu
reappears.
Entering the IP address
If DHCP is set to Off, enter the IP Address manually.
17 Press  or  to select IP Address.
18 Press [OK]. The IP Address screen appears.
19 Use the numeric keys or  or  to set the IP address.
You can set any value between 000 and 255.
Increase or reduce the figures by pressing  or .
Use  and  to move the position being entered, which is shown
highlighted.
20 Press [OK]. The IP address is stored and the IPv4 Setting menu
reappears.
Entering the Subnet Mask
When DHCP is set to Off, enter the Subnet Mask manually.
21 Press  or  to select Subnet Mask.
22 Press [OK]. The Subnet Mask screen appears.
DHCP:
Off
01
On
02
*
IPv4 Setting:
DHCP
Exit
01
Auto-IP
02
IP Address
03
Note DHCP becomes effective when On is selected. Press
[Menu] to end the mode selection menu.
When Off is set, continue on to enter the IP Address.
IP Address:
0. 0. 0. 0
IPv4 Setting:
DHCP
Exit
01
Auto-IP
02
IP Address
03
Subnet Mask:
0. 0. 0. 0

Utax P-5031DN Specifications

General

Brand	Utax
Model	P-5031DN
Category	Printer
Language	English