14
II UWATEC
®
Smart dive computer
4 Setting up Smart TEC
• Pairing of transmitter and dive computer may already be carried out at home
and need only be executed once, before the first use.
• A transmitter can only be paired with a single tank symbol at a time. If
you try to pair the same transmitter with a second tank symbol, the first
pairing will automatically be deleted.
• The pairing of transmitter and tank symbol will remain valid, even if the
gas mixture is switched off (-> 34, switching off of gas mixtures).
• You may delete the pairing of transmitter and dive computer by means of
the SmartTRAK software.
How to check if transmitter and computer are paired correctly:
1. Switch on the computer manually (B and E)
2. To check the pairing of a certain tank symbol, press to select the tank
symbol. Confirm your choice by pressing for 1 second.
3. Move the computer into transmitting range of the transmitter.
4. Open the tank valve. The transmitter switches on automatically.
5. Check the display: Pairing has been carried out correctly if the pressure is
displayed within 5-10 seconds.
Check the assignment of all tanks and transmitters as well as the pairing of
transmitters and dive computer!
If the transmitter of a selected pressure tank has been correctly paired, but TEC
cannot receive the tank pressure, "- - -" will appear on the display. In that case,
check the position of transmitter and dive computer.
If the specific channel of transmission (i.e. tank) has not been paired, or if an
existing pairing has been deleted via SmartTRAK, the display will remain empty.
In that case, transmitter and computer must be paired again.
Pairing ok
Pairing not present
To Next Page
Need help?
General
