EMR
3
Setup and Operation Manual System Operating Modes
11
SETUP MODE
The user can access the Setup Mode before a delivery to change a variety of parameters that are not required to
be under weights & measure seal. Once the delivery state is active, the Setup Mode cannot be accessed. The
Setup Mode is used to enter price codes, default mode setting, single flow and fast flow knock-off values and
other non-metrological settings. The operator can exit the mode by depressing the MODE button at any time.
When in the Setup Mode the indicator will point to the setup label on the front panel. Detailed information on how
to set the parameters is explained the setup sections of this manual.
CALIBRATION AND CONFIGURATION (C&C) MODE
The C&C Mode is entered by a trained technician following instructions in the EMR
3
Installation Guide (V-R P/N
577013-758). When the display head is powered up after the C&C Mode is enabled, the C&C related parameters
of the Setup Mode are displayed. C&C Mode is used to set up various calibration and configuration parameters,
which when made, are sealed for metrological conformity. All C&C Mode parameters can be viewed by the user in
the Setup Mode, but no changes are allowed. The operator can not exit the C&C Mode until the C&C switch is
returned to its normal operating state.
To Next Page
Loading...
Need help?
General
