EMR
3
Setup and Operation Manual C&C Mode Setup Categories
35
Figure 39. Input Type Setup
Product Description
Figure 40 illustrates Product Description setup choices. You can assign up to eight products for the EMR
3
. Each
product has a type, a name, and if the Temperature Compensation option is installed, a temperature compensation
factor. The availability of temperature compensation is a factory installed option of the EMR
3
. Thermal
compensation for all products is calculated by either thermal coefficient or density, which you select in Delivery
Options Setup (page 43).
Entering a Custom Name for a Product Type
There are eight default Product Types in the EMR
3
. If you select one of the default Product Types you do not have
to accept a default Product Name. For example, if you wanted to assign Jet Fuel to Product 1, select Kerosene as
the Product Type for Product 1 and change the Product Name from Kerosene to Jet Fuel.
ress ENTER
o return to
UEL SOURCE
E
N
T
E
R
INPUT TYPE
N
E
X
T
QUADRATURE
CUR LOOP LOCAL
SINGLE PULSE
DUAL PULSE
SWITCH CLOSURE
RS-485 LOCAL
-
+
Press ENTER to
accept choice an
return to
INPUT TYPE.
E
N
T
E
R
CW COUNT UP
CCW COUNT UP
-
+
N
E
X
T
Note: If after setting count direction, the Register
Field displays a negative dispense volume, you will
have to reset this entry to the opposite direction.
Quadrature is the default.
Note: Select Quadrature for the standard
Veeder-Root Pulse Generator.
The Quadrature input type is the only input
type available in this version of software.
To Next Page
Loading...
Need help?
General
