6. Injection load remote control
7. Fuel pump
8. HV coil
9. Fuel injector
10.Lambda probe
When switched to "ON", the fuel pump starts to rotate for two seconds and then stops. When the engine
starts up, in the presence of rpm timing signal the pump is continuously supplied.
ELECTRICAL DATA
•
Pump winding resistance ~ 1.5 Ohm
•
Input current during normal functioning 1.4 to 1.8 A
•
input current to the closed hydraulic circuit ~ 2 A (to be checked with specific tool for fuel
pressure)
Check efficiency of the fuse No. 6 of 15A injection
loads, next to the battery.
Check efficiency of fuse No. 2 of 7.5A, a 7,5A live
control unit power supply, after removing the cen-
tral cover of the shield.
Injection Vespa LX 125 - 150 i.e.
INJEC - 162
To Next Page
Loading...
Need help?
General