5. MISCELLANEOUS COMMENTS
Visonic Ltd. wireless systems are very reliable and are tested to high standards. However, due to low transmitting power and limited range (required by
FCC and other regulatory authorities), there are some limitations to be considered:
A. Receivers may be blocked by radio signals occurring on or near their operating frequencies, regardless of the digital code used.
B. A receiver responds only to one transmitted signal at a time.
C. Wireless devices should be tested regularly to determine whether there are sources of interference and to protect against faults.
6. COMPLIANCE WITH STANDARDS
Compliance with
Standards
The SD-304C PG2 is designed to comply with the following standards:
Europe: EN 301 489-3, EN 50130-4, EN 300 220-2, EN 60950-1, EN 50130-5, EN 50131-1, EN 50131-6+A1, EN 50131-2-6,
Grade 2, Class II, CLC/TS 50131-2-8.
Certified by Applica T&C.
UK: This product is suitable for use in systems installed to conform to PD6662:2010
USA: CFR 47 part 15 (FCC); FCC ID = WP3SD304CPG2
Canada: RSS 210; IC ID = 1467C-SD304CPG2
Hereby, Visonic Ltd. declares that the radio equipment type SD-304C PG2 is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
http://www.visonic.com/download-center.
This device complies with Part 15 of the FCC Rules and with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
The Power G peripheral devices have two- way communication functionality, providing additional benefits as described in the
technical brochure. This functionality has not been tested to comply with the respective technical requirements and should
therefore be considered outside the scope of the product’s certification.
Wood Supports Soft Iron
Opening Closing Direction Opening Closing
20mm+/-
5mm
14mm+/-
6mm
X 15mm+/-
5mm
14mm+/-
5mm
14mm+/-
5mm
15mm+/-
5mm
Y 15mm+/-
5mm
14mm+/-
5mm
25mm+/-
5mm
24mm+/-
5mm
Z 25mm+/-
5mm
24mm+/-
5mm
Figure 5: Axis Definitions
FCC Compliance Statement
The digital circuitry of this device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio and
television reception. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause such
interference, which can be verified by turning the device off and on, the user is encouraged to eliminate the interference by one or more of the following
measures:
l Re-orient or re-locate the receiving antenna.
l Increase the distance between the device and the receiver.
l Connect the device to an outlet on a circuit different from the one which supplies power to the receiver.
l Consult the dealer or an experienced radio/TV technician
IC statement:
This device complies with Part 15 of the FCC Rules and with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisee aux deux
conditions suivantes :(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioelectrique subi,
meme si le brouillage est susceptible d'en compromettre le fonctionnement.
D-304286 SD-304C PG2 Installation Instructions 5
To Next Page
Loading...
Need help?
General
