Replacing bulbs
Headlights
Your Volkswagen
is
equipped with
double filament seven inch sealed beam
units.
Should it become necessary to
replace a unit, loosen screw in the center
of the trim ring below the headlight and
takeoff
the trim
ring:
Firmly grasp the loose screw - a
removable) and pull trim ring off.
non-
Remove three short screws -b- in
sealed beam retaining ring and take ring
off.
Do
nol
alter the position
ol
the long
headlight adjustment screws (- c -).
Take sealed beam unit out of support
ring and pull cable connector off.
When installing new sealed beam units,
be sure the three glass lugs engage
properly in the support
ring.
Loosely Insert the screw for the trim ring
and turn for 2 or 3 turns.
Position edge of trim ring over upper
lug.
Press ring over lug and tighten
screw.
If no other headlight part as described
here was removed or its position chang-
ed,
it should not be necessary to aim
the headlights. If in doubt have the ad-
justment checked at your dealer
Front turn signal/parking light bulb
or side marker light bulb
Remove two Phillips screws.
Take off housing and lens.
Gently press bulb into holder, turn and
take out.
Install new bulb.
Be sure the gasket
is
properly positioned
when reinstalling the housing and lens.
Tighten screws
evenly
Do not
over-
tighten as
this
may crack the lens.
To Next Page
Loading...
Need help?
General
