The system menu has the following setting functions:
Menu item Meaning
System Information Systeminformation(serialnumber,rmwareversion,etc.)
Factory Parameter Reset to factory settings
Language Menu language selection
Volume Signal volume adjustment (High, Medium, Low, Off)
Backlight Display brightness adjustment (High, Medium, Low)
Capacity Limit Capacity limit adjustment (On, Off)
If the capacity limit is exceeded, the charging/discharging process will be
interrupted.
Auto Charge Setting selection time for automatic charging (5 s, 3 s, Off)
Cycle Display Setting automatic display switching for active slots (cycle display 10 s, 5 s,
Off)
Back Ends the system setup and returns to the main display.
1Setting the menu language
On initial operation, set the menu language to your national language. If your local language is not
available, you can select English.
10. Program Selection
a) Automatic charging programme
The charger automatically detects the inserted cell and sets the optimal parameters for the charging
process.
The following charging currents can be used as presets depending on the battery type:
Battery type
AAA/10440 AA/10500 18650 26650
Charging current
0.5 A 1A 2A 2.5A
The charger adjusts the charging current based on the rechargeable battery length or
the charging slot used. If you use, for example, a long thin cell with a small capacity
such as type 14650/16650, the charging current must be manually adjusted to the cell.
NiZn and LiHv rechargeable battery cells must always be adjusted manually.
36
To Next Page
Loading...
Need help?
General
