VOLTCRAFT IPC4 User Manual

5Selecting cycles
Once the “Cycle” programme has been selected, you can adjust the discharge-charge cycles as needed.
By default, 3 cycles are preset by the charger. If this value is to be changed, select the “Cycles” subitem
andconrmtheselectionusingthemiddlebutton.
Youcannowselectthedesirednumberofcyclesusingthearrowbuttonsandthenconrmtheselection
using the middle button.
6Starting the process
After all parameters have been set according to your wishes, you can start the programme using the
“►Startprocess”menuitem.
Usethearrowbuttonstoselectthismenuitemandthenusethemiddlebuttontoconrmtheselection.
The programme will start.
If no selection is made within approx. 15 seconds, the programme will start automatically.
11. USB charging
You can use the rear USB-A output (5) to charge any device that is normally charged via a USB charging
cable. The maximum output current of the USB port is 2.1 A.
Please note that using the USB output during charging will automatically reduce the
performance of the charging slots.
41

VOLTCRAFT IPC4 Specifications

General

Brand	VOLTCRAFT
Model	IPC4
Category	Battery Charger
Language	English