Emergency shifting
If a fault occurs which prevents the revers gear from
being operated (shifted) with the control lever, it is
possible to shift manually, using the description below.
Reverse gear
This description is for manual engagement of the re-
verse gear, for forward travel.
Note. The descriptions refer to electrically shifted re-
verse gear.
Manual engagement of the reverse gear:
1. Stop the engine and remove the ignition key from
the ignition lock.
2. Undo the screw (1) on the side where the cable
harness marked A is connected.
3. Remove washer (2) and tighten the screw.
4. Undo cables A and B from the solenoid valves.
1
2
A
B
Emergency trimming
If a fault occurs which prevents the drive from being
trimmed with the trim panel, it is possible to perform
an emergency trimming, using the description below.
WARNING! When emergency trimming is per-
formed, the automatic stop will not work. The
drive can be trimmed outside the trim ranges,
this can damage boat or drive.
1. Press -button on the control panel and hold.
2. Trim the drive using the trim panel.
To Next Page
Loading...
Need help?
General
