Oil filter, Change
Change the oil filters during each oil change.
WARNING!
Hot oil and hot surfaces can cause burns.
Removal
1
Drain the oil according to the instructions in
Engine Oil, Change, page 71.
NOTICE! Position a suitable vessel underneath
the filter to avoid oil spillage.
2 Clean around the oil filter.
3 Carefully remove the oil filter cover (1) and filter.
4 Remove the O-ring (2) and filter (3)
5 Let the oil drip off into a collection vessel.
Installation
6 Install a new filter (3) and a new O-ring (2).
7 Install the filter cover (1) and filter.
Torque to: 40 Nm (29.5 lbf.ft.)
8 Fill with required volume of oil, see Engine Oil,
Change, page 71.
Carry out a function test
•
Start the engine.
•
Check that there is no oil leakage from the oil filter
or drain nipple.
•
Turn off the engine.
•
Check the oil level after a few minutes.
•
Top up with oil as necessary.
Engine Model
Spec.No
Serial No kw(G)redkw(G)red
rm
Kw(S)red
C
Kw(G) Kw(S)
Kw(W)
MAID IN GERMANY
1/min
7
Maintenance
70
47711097 09-2018 © AB VOLVO PENTA
To Next Page
Loading...
Need help?
General
