Transport to the worksite
T01111en.fm 16
5. Transport to the worksite
Requirements:
∗ When transporting the floor saw, use only suitable hoisting gear with a
minimum load-bearing capacity of 150 kg.
∗ Always turn off the motor during transportation!
∗ Empty the water tank!
∗ Remove the cutting blade prior to transport. Set the lowest cutting po-
sition on the floor saw.
∗ Remove the water tank and attach the hoisting gear on the transport
strap (1) for lifting.
∗ If you transport the floor saw on the cargo area of a vehicle, strap it
down securely on the special safety bar.
∗ Fold the guide wheel to the top and the handles to the front (or the stir-
rup handle to the top).
∗ Handles, guide wheel and other operating controls must not be used
as attachment points.
Note: Also observe the regulations in the chapter Safety information.
To Next Page
Loading...
Need help?
General
