Operation
T01110en.fm 18
6.2 Adjusting / Aligning the guide wheel
6.2.1 Adjusting the guide wheel
The guide wheel is designed to help the operator in making long,
straight cuts. The guide wheel can be exactly adjusted to the cutting
blade by loosening the jam nut (1) and turning the screw (2).
6.2.2 Aligning the guide wheel
To do this, make a cut of approx. 2 m length on a flat surface and with
the minimum cutting depth. Then pull back the machine without lateral
force. Then you can align the guide wheel exactly with the cut.
To Next Page
Loading...
Need help?
General
