4 Safety
12 100_0202_si_0005.fm
Ear protection
This machine generates noise that exceeds the country-specific permissible noise levels (individual
rating level). It may therefore be necessary to wear ear protection. You can find the exact value in the
chapter Technical Data.
When wearing ear protection while working, you must pay attention and exercise caution because your
hearing is limited, e.g. in case someone screams or a signal tone sounds.
Wacker Neuson recommends that you always wear ear protection.
4.4 Transport
Switching off the machine
Before you transport the machine, it must be switched off, and the engine must be given sufficient time
to cool down.
Center pole in transport position
Before commencing transport, move the center pole to the transport position. Let the center pole latch
into its lock.
Observing hazardous materials regulations
Observe the national safety guidelines and the hazardous materials regulations that apply to the
respective means of transportation.
Lifting
When lifting the machine, observe the following instructions:
Designate a skilled person to guide you for the lifting procedure.
You must be able to see or hear this person.
Use only suitable and certified hoisting gear, lifting tackle and load-bearing equipment with sufficient
lifting capacities.
Only use the attachment points described in the operator's manual.
Attach the machine securely to the hoisting gear.
Ensure that no one is nearby or under the machine.
Do not climb onto the machine.
Loading the machine
Loading ramps must be able to bear the load and be in a stable position.
Make sure that no one can be endangered if the machine slips away or tips over or if machine parts
suddenly move upward or downward.
Put the operating controls and moving parts in their transport position.
Secure the machine with load-securing straps so that it cannot tip over, fall down or slide away. Only use
the attachment points described in the operator's manual.
Transport vehicle
Use only suitable transport vehicles with sufficient load-carrying capacity and suitable tie-down lugs.
Transporting the machine
Secure the machine on the transport device against tilting, falling or slipping.
Only use the lashing points listed in the operating instructions.
Also observe the country-specific regulations, standards and guidelines.
Restarting
Machines, machine parts, accessories or tools that were detached for transport purposes must be re-
mounted and fastened before restarting.
Only operate in accordance with the operating instructions.
To Next Page
Loading...
Need help?
General
