Wacker Neuson DPU Series User Manual

3 Security
100_0202_si_0008.fm 10
 In the case of extensive work with this machine, long-term vibration-induced damage cannot be ruled
out. For exact values of vibration measurement, refer to the Technical Data chapter.
 Wear suitable clothing. Keep loose clothing, gloves, jewelry, and long hair away from moving/rotating
machine parts. Danger of being pulled!
 Ensure that no other individuals are in the danger zone!
3.6.4 Handling and use
 Handle machines with care. Do not operate machines with defective components or operator’s
controls. Immediately replace defective components or operator’s controls. Machines with defective
components or operator’s controls carry a high risk of injury!
 The operator’s controls of the machine shall not be improperly locked, manipulated, or changed.
 The machine, accessories, and tools should be used in accordance with these instructions.
 Store unused machines out of reach of children. The machine may only be operated by authorized
personnel.
 After operation, store the cooled-down machine in a locked, clean, frost-protected, and dry location
that is inaccessible to children and other unauthorized individuals.
3.7 Specific safety instructions – Vibratory plates
3.7.1 External influences
In the case of the following external influences, the vibratory plate may not be operated:
 In heavy rain on sloped surfaces. Risk of slipping!
 Oilfield environments – methane leaks from bottom. Risk of explosion!
 In dry, flammable vegetation. Fire hazard!
 In potentially explosive areas. Risk of explosion!
3.7.2 Operational safety
 When operating the machine, make sure that no gas, water, or electric lines are damaged.
 The machine must not be operated in tunnels or enclosed spaces.
 Pay maximum attention near drops or slopes. Risk of crashing!
 The operator must not leave the machine while it is in operation.
 Do not leave the machine unattended. Risk of injury!
 Delimit spacious workspace and restrict access to unauthorized individuals. Risk of injury!
 The operator of the machine must ensure that all individuals keep a minimum distance of 2 m from
the machine while it is in operation.
 Do not use any jumper cable sprays. This can cause misfires and engine damage. Fire hazard!
 When operating the machine on sloped surfaces, always approach slopes from below and always
stay above the machine on a slope. The machine could slip or tip over.
 Do not exceed max. allowable slanting position of the machine – possible failure of the engine
lubrication, see chapter Technical Data.
 Only Wacker Neuson use starter batteries. These are vibration proof and therefore suitable for the
high vibration exposure.
3.7.3 Safety distances
Compaction work near buildings can cause damage to buildings. Therefore, all potential effects and
vibrations on surrounding buildings must be checked in advance.
The relevant rules and regulations for measuring, evaluating, and reducing vibration emissions –
especially the DIN 4150-3 – must be considered.
Wacker Neuson assumes no liability for any damage to buildings.
3.8 Specific safety instructions – remote controlled vibratory plates
 Always keep remote control and receiving units of the machine clean and free from dry, oil, and
grease.
 Remote control and receiving units must not be taped over or covered.
 During operation, the remote control should always be aimed directly at the machine. A clear line of
sight must be maintained – infrared signals can be reflected.
 The operator should remain at least 5 meters behind the machine.
3.9 General safety instructions – combustion engines
The following instructions must be complied with:

Wacker Neuson DPU Series Specifications

General

Brand	Wacker Neuson
Model	DPU Series
Category	Power Tool
Language	English