Wacker Neuson DPU Series User Manual

9 Maintenance
45 100_0202_mt_0011.fm
9.4 Maintenance jobs
Carry out preparations
1. Place the machine on a level surface.
2. Decommissioning the machine.
3. Deactivate machine.
4. Allow the engine to cool down.
9.4.1 Check the fuel level and top up if necessary
1. Open rear protective hood.
2. Remove dirt accumulation in the area of the fuel cap.
3. Unscrew the fuel cap of the fuel tank and remove it.
Maintenance jobs every 1000
h/every 2
years
every 4000
h/every 4
years
every 6
years
Replace coolant.* 
Replace the hydraulic oil.* 
Replace the tooth belt pulley of the engine.* 
Replace the hydraulic hose lines.* 
*
Have this work done by the service of Wacker Neuson.
CAUTION
Health hazard from fuel, lubricants and coolants
 Do not inhale vapors from fuel, lubricants and coolants.
 Avoid contact from fuel, lubricants and coolants with skin or eyes.
WARNING
Fire and explosion hazard from fuel and fuel vapors
 Do not smoke.
 Do not refuel near open flames.
 Switch off engine and allow to cool before refueling. Only refuel in a well-ventilated
vicinity.
Item Designation Item Designation
1 Limit mark 3 Fuel filter
2 Fuel cap

Wacker Neuson DPU Series Specifications

General

Brand	Wacker Neuson
Model	DPU Series
Category	Power Tool
Language	English