3 Safety
100_0101_si_0001.fm 17
Extension cable
The machine may only be operated with undamaged and tested extension ca-
bles!
Only use extension cables with grounded conductor and correct connection of
the grounded conductor to the plug and coupling (only for machines of class rat-
ing I, see chapter Technical data).
Only use tested extension cables which are suitable for use at construction sites:
Average rubber hose H05RN-F or better – Wacker Neuson recommends
H07RN-F, an SOOW cable, or a country-specific equivalent design.
Immediately replace damaged extension cables (e.g. tears in the sheathing) or
loose plugs and couplings.
Cable drums and multiple plug receptacles must fulfill the same requirements as
the extension cable.
Protect extension cables, multiple plug receptacles, cable drums and connection
couplings against rain, snow or any other forms of moisture.
Uncoil the cable drum completely
Danger of fire due to wound cable drum.
Uncoil the cable drum completely before operation.
Protecting the power cable
Do not use the power cable to pull or lift the machine.
Do not unplug the power cable by pulling on the cable.
Protect the power cable from heat, oil and sharp edges.
If the power cable is damaged or the plug is loose, have it replaced immediately
by your Wacker Neuson representative.
Protecting the protective hose
Do not drag the protective hose over sharp edges.
If the vibrator head jams in the reinforcement, do not pull out the protective
hose suddenly or violently. Free the vibrator head by carefully moving it back
and forth.
3.8 Maintenance
Maintenance work
Service and maintenance work must only be carried out to the extent described
in these operating instructions. All other procedures must be performed by your
Wacker Neuson representative.
For further information, refer to chapter Maintenance.
To Next Page
Loading...
Need help?
General
