Wacker Neuson SW10 User Manual

16
DRIVER’S SEADRIVER’S SEA
DRIVER’S SEADRIVER’S SEA
DRIVER’S SEA
TT
TT
T
The driver’s seat must not be adjusted while the vehicle is moving.
Danger of accidents!
Always fasten the seatbelts.
The driver’s seat is important for good health. Therefore it must be maintained integral.
The driver’s seat can be adjusted longitudinally using the special lever positioned low on the right
hand side.
SAFETY BELSAFETY BEL
SAFETY BELSAFETY BEL
SAFETY BEL
TSTS
TSTS
TS
FASTENING:
Sit properly in the driver’s seat, adjust the belt length, check that
it is not twisted, then insert the clip A into the housing B until
locked.
UNFASTENING:
Press the button C and remove the belt from the fixed part plac-
ing it to the right of the driver.
SAFETY BARSAFETY BAR
SAFETY BARSAFETY BAR
SAFETY BAR
Every machine is equipped with a safety bar that together with the safety belts and cabin in
compliance with ROPS and FOPS makes up the operator’s “safety girdle”.
The machine must always be driven with safety bar lowered and safety belts fas-
tened.
FUNCTIONS OF THE SAFETY BAR
A - SAFETY BAR RAISED:
- Start-up of the diesel engine
- The servo-controls are deactivated
- The lifting arms are blocked
B - SAFETY BAR LOWERED:
- The diesel engine does not start-up
- The servo-controls are activated
- The arm control is deactivated.
For activation of the arm control
(ascent/descent) press the button (Fig.1 - ref.4)
A
B
C
OPERATOR CONTROLS
ATTENTION
If the safety bar rises the hydraulic servo-controls are deactivated and the lifting arm blocked.
POSITION A
POSITION B

Wacker Neuson SW10 Specifications

General

Brand	Wacker Neuson
Model	SW10
Category	Compact Loader
Language	English