Wacker Neuson SW10 User Manual

59
CAUSE
REMEDY
UNSUITABLE HYDRAULIC OIL
HYDRAULIC PIPES BLOCKED
HYDRAULIC FILTER CLOGGED
HYDRAULIC PUMPS DAMAGED
MAX. PRESSURE VALVES FAULTY,
NOT CALIBRATED
HYDRAULIC OIL LEVEL LOW
FROTHY OIL DUE TO INFILTRATION
OF AIR
HYDRAULIC OIL DIRTY
MANOEUVRES NOT CONFORM
WITH MACHINE USE
HIGH
HYDRAULIC
OIL T
EMPERATURE
FAULT
HYDRAULIC SYSTEM
USE RECOMMENDED OIL
CALL AN AUTHORISED WORKSHOP
REPLACE
CHECK, CALL AN AUTHORISED
WORKSHOP
CHECK, CALIBRATE AND REPLACE IF
NEEDED
INSPECT, RESTORE
REMOVE THROUGH PUMP SUCTION
CHECK AND REPLACE IF NECESSARY
USE THE MACHINE LINEARLY
WITHOUT FORCING THE CONTROLS.
(IN PARTICULAR WITH CYLINDERS AT
END OF TRAVEL)
HYDRAULIC OIL OVERHEATING
COOL FOR THE APPROPRIATE TIME
SLOW MOVEMENT OF
HYDRAULICALLY
CONTROLLED PARTS
(insufficient
performance)(follows)
CAUSE
REMEDY
ALTERNATOR DOES NOT RECHARGE
ELECTROLYTE LEVEL LOW
TERMINALS LOOSE OR OXIDISED
ALTERNATOR BELT FAULTY
CHECK BELT TENSION EFFICIENCY,
RE-PLACE ALTERNATOR (CALL AN
AUTHOR-ISED WORKSHOP)
CHECK, TOP UP
INSPECT, CLEAN, TIGHTEN
CHECK, RESTORE TENSION, REPLACE
GENERATOR
LIGHTON
FAULT
BATTERY DOES
NOT RECHARGE
INSPECT, REPLACE
INSPECT, CLEAN, TIGHTEN
CHECK LEVEL , REPLACE
REPLACE, USE RECOMMENDED OIL
THE STARTER
TURNS VERY
SLOWLY
STARTER FAULTY OR BROKEN
BATTERY CLAMPS OXIDISED OR
LOOSENED
BATTERY FLAT
INCORRECT ENGINE OIL
MAINTENANCE

Wacker Neuson SW10 Specifications

General

Brand	Wacker Neuson
Model	SW10
Category	Compact Loader
Language	English