Wacker Neuson SW10 User Manual

45
REFILLINGREFILLING
REFILLINGREFILLING
REFILLING
,,
,,
,
INSPECTIONS INSPECTIONS
INSPECTIONS INSPECTIONS
INSPECTIONS
AND CHECKSAND CHECKS
AND CHECKSAND CHECKS
AND CHECKS
A - Pressurised filling cap (0.7 bar) to re-
store the level of engine cooling liquid.
B - Engine cooling liquid level indicator.
C - Radiator filling cap (supply complete).
D - Hydraulic oil introduction cap. (38 spanner).
E - Fuel introduction cap
FUEL SUPPLY SYSTEM
The fuel tanks are situated on the rear left and right sides of the machine; their lower parts are
connected with a lower pipe. The fuel introduction cap “E” is on the left tank and is accessible by
opening the engine hood.
A special indicator (Fig.1 - ref. 1) on the dashboard signals when it goes into reserve.
Avoid emptying the tank completely, since due to the air entering the system, the diesel engine
would fail to start once refilled if the circuit is not drained beforehand.
When filling the tank with fuel, use a funnel fitted with a very fine metallic mesh filter to avoid
problems with the injection system due to solid impurities which may be present in the fuel.
Concerning the addition of additives for use at the different temperatures, in particular in cold
climates, follow the instructions in the use and maintenance manual of the engine manufacturer,
supplied with the machine.
- Total tank capacity l 42
MAINTENANCE

Wacker Neuson SW10 Specifications

General

Brand	Wacker Neuson
Model	SW10
Category	Compact Loader
Language	English