7
Check that the ramps are properly coupled to the transport vehicle and appropriately
spaced.
The width of the ramp must be such as to allow comfortable passage of the tyres.
The ascent and descent operations must always be carried out with the machine running and the
hydraulic oil at operating temperature.
Do not use the ramps as a gangway for crossing from one vehicle to the next.
For loading and unloading of the machine it is recommended to ascend in reverse gear and de-
scend in forward gear. In both cases it is recommended to keep the arm lowered and the bucket
turned downwards, parallel to the ramps. Block the eventual lowering of the loading platform with
a truss or other equipment.
Before ascending or descending, check perfect alignment between the tyres and the
ramps. Do not steer or adjust direction while on the ramps. If necessary, return to the point
of departure, repositioning correctly.
Caution of passage in the connection area between the ramps and the loading
platform of the truck; the steep slope must be negotiated by moving very slowly and with
extreme caution. Be twice as careful in the descent phase since the unbalance towards the bottom
in this case is much higher. It is recommended to lower the arms and turn the bucket forwards to
allow eventual emergency shutdown.
All the loading and unloading operations of the machine must be carried out and co-
ordinated by at least a second person who controls good progress of the operations.
TRUSSES
BELTS
WEDGES
PRESENTATION OF THE MACHINE
To Next Page
Loading...
Need help?
General
