Wacker Neuson WM 90 User Manual

WM 90 Repair Reassembly Procedures
wc_tx000389gb.fm 69
8.19 Re-installing Engine
See Graphic: wc_gr001954, wc_gr003661, wc_gr001956, and wc_gr001957
8.19.1 Position the engine so that mounting studs protrude from the adapter
plate mounted to the rammer crankcase. Position heatshield and
secure engine and heatshield to rammer with four nuts (j).
8.19.2 Connect the wire from the low-oil unit (l) (if equipped) to the engine.
8.19.3 Using six M8 bolts (f) mount the guards to the engine. Secure upper
guard to engine using M8 x 16 bolt (d) and to rammer crankcase using
M8 bolt (e).
8.19.4 Secure the throttle cable to the engine by crimping clamp (h). Feed
cable through retainer (g) and tighten screw.
8.19.5 Secure air intake hose to engine by crimping clamp (i).
8.19.6 Reconnect stop switch wire (c).
8.19.7 Connect the wiring (k) from the low-oil unit (l) (if equipped).
8.19.8 Reconnect fuel line (b) to the carburetor.
8.19.9 Reconnect spark plug (a).

Wacker Neuson WM 90 Specifications

General

Brand	Wacker Neuson
Model	WM 90
Category	Engine
Language	English