WAGNER F230 User Manual

6
VM 500
OPERATING MANUAL
EDITION 03/2012 PART NUMBER DOC 2318724
2 GENERAL SAFETY INSTRUCTIONS
2.1 SAFETY INSTRUCTIONS FOR THE OPERATOR
2.1.1 ELECTRICAL EQUIPMENT
2.1.2 PERSONNEL QUALIFICATIONS
2.1.3 A SAFE WORK ENVIRONMENT
Keep these operating instructions to hand near the unit at all times.
Always follow local regulations concerning occupational safety and accident prevention.
Electrical plant and unit
To be provided in accordance with the local safety requirements with regard to the
operating mode and ambient influences.
May only be maintained by skilled electricians or under their supervision.
Must be operated in accordance with the safety regulations and electrotechnical
regulations.
Must be repaired immediately in the event of problems.
Must be put out of operation if they pose a hazard.
Must be de-energized before work is commenced on active parts. Inform staff about
planned work, observe electrical safety regulations.
 %NSURETHATTHEUNITISOPERATEDANDREPAIREDONLYBYTRAINEDPERSONS
Make sure that the floor in the area where you are working is anti-static in accordance
with EN 61340-4-1 (the resistance value may not exceed 100 MOhm).
Ensure that all persons within the working area wear antistatic shoes. Footwear must
comply with EN 20344. The measured insulation resistance may not exceed 100 MOhm.
Ensure that during spraying, persons wear anti-static gloves so that they are earthed
via the handle of the spray gun.
If protective clothing is worn, including gloves, it has to comply with EN 1149-5. The
measured insulation resistance may not exceed 100 MOhm.
Paint mist extraction systems must be fitted on site according to the local regulations.
Ensure that the following components of a safe working environment are available:
– Material/air hoses adapted to the working pressure.
– Personal safety equipment (breathing and skin protection).
Ensure that there are no ignition sources such as naked flame, glowing wires or hot
surfaces in the vicinity. Do not smoke.
Control units
Place the control unit outside the spray booth/zone.
Place the control unit, if possible, outside the explosion zone (positioning in explosion
zone 2 is enables).
Protect the control unit from extreme temperature and moisture changes.
Protect the control unit against dirt.
Lay and fix the connecting cable correctly.
Guarantee that local mains voltage and tension of the equipment agree.

WAGNER F230 Specifications

General

Brand	WAGNER
Model	F230
Category	Paint Sprayer
Language	English