MultiControl | SmartControl | UniBox 6
4 Installation of the Control Element
4.1 Recommendations for installation
CAUTION!
Electric shock if live parts are touched
Minor burns
Isolate the vehicle before installation (vehicle
initialisation may be lost).
CAUTION!
Risk of fire due to incorrect installation
Risk of burns
Observe the additional regulations if installing the
heater in vehicles for hazardous goods transport.
Observe the information on the identification
plate.
CAUTION!
Risk of fire caused by drilling into lines or
cables
Risk of burns
Lay lines and cables behind the installation sur-
face out of the drilling area.
CAUTION!
Risk of injuries caused by touching sharp
edges
Skin abrasions, cuts
Use protective gloves during installation.
4.2 Requirements for the installation loca-
tion
The installation location must satisfy the following requirements:
3
Vehicle interior
3
Easily accessible
3
Clear visibility
3
Clean, dry and grease-free
3
Protected from dampness and moisture
3
Protected from heat, not directly in the hot air current
3
Adequate free space behind the installation location
4.3 Install control element
Installation with adhesive pads
123
Fig. 02: Install control element with adhesive pads
1 Installation location
2 Adhesive pads (adhesive on both sides)
3 Control element
Determine the installation location.
When determining the location, pay attention to
the length of the control element cable.
Determine the location for the leadthrough of the control ele-
ment wiring harness.
Lay the control element wiring harness through from the front.
3
The rear side of the control element is clean, dry and free from
dust or grease.
Attach the adhesive pads to the control element.
Attach the control element to the selected installation location.
To Next Page
Loading...
Need help?
General
