weinor BiRec MVLED User Manual

BiConnect BiRec MVLED/MLED
Version 4
2020-07-08
Assembly and installation instructions/ Instructions de montage et d’installation
Item number/
We reserve the right to make technical changes/ Sous reserve de modifications techniques
Numéro d’article
116692-0000
Page 11/28
6 Troubleshooting
Type of fault
Cause
Remedy
Awning/light does not react to
the signal sent by the hand
transmitter
• No power supply
• Reconnect power supply
• Awning/light has not been
programmed
• Program awning/light
• Empty batteries in hand
transmitter
• Replace batteries
Drive moves in wrong
direction
• Directions have been
programmed incorrectly
• Delete channel and
program correctly
Following a DOWN
command, awning extends
only a short way, then
immediately retracts
• Receiver is in lock mode:
maximum wind factor on
sun/wind or sun/wind/rain
sensor exceeded
• Lock mode is removed
automatically 15 minutes
after the maximum wind
factor was last exceeded
• BiSens Agido-3V product
protection sensor has been
triggered in last few minutes
• The device unlocks
automatically after 15-20
minutes
• Programmed sun/wind or
sun/wind/rain sensor is
faulty or incorrectly installed
• The device will only
unlock when the fault has
been remedied
Awning moves UP and
cannot be halted or extended
• "Wind alarm":
Programmed sun/wind
and/or sun/wind/rain sensor
or BiSens Agido-3V product
protection sensor has been
triggered
• The device unlocks
automatically after the
designated period
Following an UP command,
the awning stops after a while
then continues
• BiSens Agido-3V
battery empty
• Replace batteries in a
programmed BiSens
Agido-3V product
protection sensor
The awning cannot be
taught in
a) with the BiEasy hand
transmitter
b) with the Remoto hand
transmitter
a) the unidirectional
transmitter/ sensor e.g.
Remoto is still taught in
b) the bidirectional
transmitter/ sensor e.g.
BiEasy is still taught in
• delete old transmitter
completely then teach in
the awning with the new
transmitter
The light programming
procedure does not start
automatically after completion
of the drive programming
procedure.
A transmitter has already been
programmed on the receiver.
• Programming another
transmitter on the
receiver using the
transmitter already
programmed on this
receiver. (see 5.4)
• Delete all recipients on
the transmitter (see 5.5)
and program the awning
and light again (see 5.2)
Table 3: Troubleshooting

weinor BiRec MVLED Specifications

General

Brand	weinor
Model	BiRec MVLED
Category	Receiver
Language	English