BiConnect BiRec MVLED/MLED
Assembly and installation instructions/ Instructions de montage et d’installation
We reserve the right to make technical changes/ Sous reserve de modifications techniques
2 Safety notes
2.1 Fundamental safety notes
• Keep unauthorised persons away from the unit until it is ready for use.
• The connected electrical load must tally with that listed in the technical data.
• The regulations of the local energy providers and the VDE 0100 provisions for humid and
wet areas must be observed.
• Only connect the remote-receiver to devices approved by weinor.
2.2 Dangers of electricity
• Work involving connections to 230 V mains may only be carried out by a trained electrician.
• Disconnect the unit from the power supply before performing any work.
•
weinor recommendation: a residual current circuit breaker (trip switch) should also be fitted
to protect the indoor installation.
2.3 Risk of fire when operating a radiant heater (BiRec MVLED only)
• Check the safety function: the awning must extend fully first, followed by the Valance Plus.
• The optional heater must be connected and protected with fuses separately (see the
heater's assembly instructions).
2.4 Risks from the Valance Plus (BiRec MVLED only)
• Check the retraction protection: the awning must extend fully first, followed by the Valance
Plus. In the case of retraction, the Valance Plus must retract fully first, followed by the
awning.
• While the Valance Plus is extending, touching it may result in electrostatic discharge.
2.5 Intended use
The BiRec MVLED/MLED remote-receiver is exclusively intended for controlling weinor awning
drives and the weinor lighting system.
2.6 Improper use
The remote-receiver may only be used on the condition that a malfunctioning hand transmitter
or remote-receiver does not pose a danger to people, animals or objects. The device may only
be connected to devices and units approved by weinor. The system may not be operated in
areas where the transmitted signals might interfere with other devices (e.g. in hospitals or at
To Next Page
Loading...
Need help?
General
