BiConnect BiRec MVLED/MLED
Assembly and installation instructions/ Instructions de montage et d’installation
We reserve the right to make technical changes/ Sous reserve de modifications techniques
4 Getting started
4.1 Pre-programmed system
The system is usually supplied pre-programmed. This means that all the components can be
controlled with the hand transmitter supplied. In this case, once the system is assembled and
installed, you can immediately start using the remote-receiver and check that all the functions
4.2 Unprogrammed system
On rare occasions or if servicing has been carried out, however, the system will need to be
programmed on site. This is done by pairing up the hand transmitter and remote-receiver and
setting them to various functions (see Section 5).
4.3 Checking the functions
Once all the installation work is completed, you will need to check that the system is working
properly and that the individual components are paired.
Valance Plus working?
• Does the awning extend
fully first, followed by the
Valance Plus?
• Does the Valance
Plus retract fully first,
Briefly press DOWN key
Awning extends fully, followed
by Valance Plus (to sun
protection position).
Briefly press UP key
Valance Plus retracts fully,
followed by awning.
• Is the light working?
Double-click
The light switches on.
• Can the light be dimmed?
Press and hold the UP key
The light gets brighter.
Press and hold the DOWN
key
The light gets darker.
• Are all the sensors (if they
are being used)
programmed to the correct
direction?
• Simulated "wind" on the
sun/wind (or
sun/wind/rain) sensor
• Shake the drop profile (if
an Agido product
protection sensor is
Table 2: Checking the functions
If the components do not react as expected, check the table below to locate the likely cause.
To Next Page
Loading...
Need help?
General
