Safety | 2 | English
Operating instructions PT Series | 89014547; 2021-03 | 5
2 Safety
2.1 Safety notes
Winterhalter Gastronom GmbH assumes no liability or warranty in the event of non-compliance with
these safety and operating instructions.
General safety notes
– This warewasher can be used by children aged 8 years and above and by persons with reduced
physical, sensory, or mental capabilities, or lack of experience and knowledge, if they are super-
vised or have been instructed in the safe use of the machine and understand the dangers in-
volved.
– Children must not play with the warewasher.
– Cleaning and user maintenance should not be carried out by children without supervision.
– Read through the safety notes and operating instructions carefully.
– Retain the operating instructions for future reference.
– Only use the warewasher after you have read and understood the operating instructions and the
safety notes.
– Allow the Winterhalter Customer Service Department to provide information about the operation
and functioning of the warewasher.
– Train operating personnel in handling the warewasher and point out any and all safety notes. Re-
peat the training sessions at regular intervals to prevent accidents.
– Operate this warewasher only when it is in perfect condition.
– A damaged or leaking warewasher may endanger safety. If malfunctions occur, switch off the
warewasher immediately and switch it back on only once the malfunction has been remedied.
Switch off the on-site mains isolation switch (main switch) to ensure the warewasher is voltage-
free.
– Allow the installer or an electrician to remedy on-site water and electricity supply malfunctions.
– Allow other malfunctions to be remedied by an authorised service technician or your dealer.
– Once the work is complete, close the on-site water supply.
– After finishing work, switch off the machine using the self-cleaning programme.
Electrical safety
– Do not open any machine covers or machine parts if doing so requires tools. There is a danger of
electric shock.
– The electrical safety of this machine is guaranteed only if it is connected to a correctly installed
protective circuit. It is crucial that this basic safety requirement is tested and, in case of doubt, that
the on-site installation is checked by a qualified electrician.
Winterhalter cannot be held responsible for damage caused by a missing or broken protective
conductor (e.g. electrical shock).
– Work on the electrical system may only be carried out by qualified specialists. When working on
the electrical system, observe the electrical engineering safety rules to avoid electrical accidents:
– Disconnect all power supply points.
– Secure the machine against being switched on again.
– Check that there is no voltage present.
– Earth and short circuit.
– Cover or cordon off neighbouring parts that are live.
– If the mains cable is damaged, to prevent hazards it must be replaced by Winterhalter, its Cus-
tomer Service Team or another qualified person. The mains cable must be a H07RN-F type or
equivalent.
To Next Page
Loading...
Need help?
General
