16
Note: to convert slides, feed the first slide in the adapter, then use a
second and third slide to push the preceding ones through the adapter.
Align the picture on the viewer properly before converting. Continue
to feed slides through the adapter one by one.
E
nsure the Film Type
setting is correct, or you will see X-ray-like image on the viewer. The
film type setting will remain unchanged even when power off. For
detail process, please go to our web site to view our video manual,
refer to web site info on page 4.
Slide
1. Put Slide Adapter into F2D Super Plus.
2. Feed and push each slide until image align
properly on the viewer.
Feed in slide one by one
2
17
Negative
1. Put Negative Adapter into F2D Super Plus
2. Feed negative film and check the image
from the viewer.
10. Edit Image Orientation
At Convert Mode, press Mirror key to mirror the image left to
right, or Flip key to flip the image upside down. Or you can also
rotate the images 90 degrees while viewing at Playback mode later.
At Convert Mode, press OK/Enter key to change EV (Exposure
Value), R (red), G (green), and B (blue) color components. The
default value of EV is 0.0, change to positive(+) to make image
brighter, or negative(-) to make image darker. You can also adjust
R, G, and B color components to enhance the image quality of the
11. Change Image EV (Exposure Value) and RGB Color
To Next Page
Loading...
Need help?
General
