Xerox
®
DocuMate
®
5445 / 5460
User’s Guide
181
This option is only available when scanning in grayscale or black and white. The example below shows the original
text with a red watermark and the resulting image with the color removed.
Perform Color Correction
Apply color correction to the image so the displayed colors approximate the original item colors. Select this option to
use the scanner’s default Gamma table which has been calibrated to produce the best quality color results for your
scanner. When this option is not selected, the resulting scans will be dark and the brightness, contrast, and gamma
options will require a greater amount of adjustment to affect the overall lightness of the image.
Automatic Color Detection Options
Select Automatic in the document source configuration list to enable these options. When you have selected the
automatic color mode, you will also need to choose either Gray or Black & White.
• Ignore document color—select this option to have the scanner ignore the color of the document when
determining if the scan should be saved as a color image.
• Color percentage—input the percentage of color pixels the scanner should look for to detect and save a color
image. The scanner determines color versus black-and-white by comparing the amount of color to the amount
of black in the image. The higher the value you set in this field, the more color is needed in the original item to
detect and save it as a color image. You can set the color percentage level up to 50%. This means that only
those documents which have more than 50% of the content in color will be saved as a color image.
Advanced Panel Options
The options in this panel may also appear in the Main panel, but with additional settings for you to fine-tune the
feature you've selected. Select the Advanced source configuration mode to show this panel.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
