EasyManuals Logo
Home>Xerox>Printer>Phaser 3600

Xerox Phaser 3600 User Manual

Xerox Phaser 3600
109 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
ii
Never obstruct ventilation openings. They are provided to
prevent overheating.
Never remove covers or guards that are fastened with screws.
There are no operator serviceable areas within these covers.
Never locate the machine near a radiator or any other heat
source.
Never push objects of any kind into the ventilation openings.
Never override or "cheat" any of the electrical or mechanical
interlock devices.
Never place this equipment where people might step on or trip
on the power cord.
This equipment should not be placed in a room unless proper
ventilation is provided. Please contact your local Authorized
dealer for further information.
Electrical Safety Information
1. The power receptacle for the machine must meet the
requirements stated on the data plate on the rear of the
machine. If you are not sure that your electrical supply meets
the requirements, please consult your local power company or
an electrician for advice.
2. The socket outlet shall be installed near the equipment and
shall be easily accessible.
3. Use the power cable that is supplied with your machine. Do not
use an extension cord or remove or modify the power cord
plug.
4. Plug the power cable directly into a correctly grounded
electrical outlet. If you are not sure whether or not an outlet is
correctly grounded, consult an electrician.
5. Do not use an adapter to connect any Xerox equipment to an
electrical outlet that lacks a ground connection terminal.
6. Do not place this equipment where people might step or trip on
the power cable.
7. Do not place objects on the power cable.
8. Do not override or disable electrical or mechanical interlock
devices.
9. Do not push objects into slots or openings on the machine.
Electrical shock or fire may result.
10. Do not obstruct ventilation openings. These openings are used
to provide proper cooling to the Xerox machine.
Electrical Supply
1. This product shall be operated from the type of electrical supply
indicted on the product's data plate label. If you are not sure
that your electrical supply meets the requirements, please
consult a licensed electrician for advice.
WARNING: This equipment must be connected to a
protective earth circuit. This equipment is supplied
with a plug that has a protective earth pin. This plug
will only fit into an earthed electrical outlet. This is a
safety feature. If you are unable to insert the plug into
the outlet, contact a licensed electrician to replace
the outlet.
2. Always connect equipment to a correctly grounded power
outlet. If in doubt, have the outlet checked by a qualified
electrician.
Disconnect Device
The power cable is the disconnect device for this equipment. It is
attached to the back of the machine as a plug-in device. To remove
all electrical power from the equipment, disconnect the power cable
from the electrical outlet.
Emergency Power Off
If any of the following conditions occur, turn off the machine
immediately and disconnect the power cable(s) from the electrical
outlet(s). Contact anauthorized Xerox Service Representative to
correct the problem:
The equipment emits unusual odours or makes unusual noises. The
power cable is damaged or frayed. A wall panel circuit breaker, fuse,
or other safety device has been tripped. Liquid is spilled into the
machine. The machine is exposed to water. Any part of the machine
is damaged.
WARNING: Risk of explosion if battery is replaced
by an incorrect type. Dispose of used batteries
according to the instruction.

Table of Contents

Other manuals for Xerox Phaser 3600

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox Phaser 3600 and is the answer not in the manual?

Xerox Phaser 3600 Specifications

General IconGeneral
ColorNo
Duplex printingYes
Print technologyLaser
Maximum resolution600 x 600 DPI
Warm-up time (from sleep mode)31 s
Print speed (black, normal quality, A4/US Letter)38 ppm
Internal memory32 MB
Maximum internal memory512 MB
Total input capacity600 sheets
Total output capacity250 sheets
Maximum input capacity1100 sheets
Paper tray 2 input capacity500 sheets
FunctionsPrint
I/O portsParallel (IEEE 1284), USB 2.0
Device managerDHCP, Xerox CentreWare Internet Services Embedded Web Server, Xerox CentreWare Printer Management for Microsoft, Novell, and UNIX
Package length563.87 mm
Depth (imperial)18.8 \
Width (imperial)15.7 \
Height (imperial)15.1 \
Power requirements240 V, 50/60 Hz
Standard input trays2
Print memory (standard)64 MB
Power consumption (active)700 W
Compatible operating systemsHP-UX 10.2, Linux, Mac OS X ver.10.2 Red Hat 9, SCO, SUSE 9, Solaris 2.5.1/2.6+, Windows 2000/Vista
Acoustic power emissions (standby)35 dB
Standard output capacity for envelopes8000 sheets
Acoustic power emissions (active, print, copy or scan)56 dB
PCL fonts68
CertificationCE, UL 60950-1/CSA 60950-1-03, FCC Part 15 Class A, 73/23/EEC, RoHS 2002/95/EC
Maximum duty cycle200000 pages per month
Recommended duty cycle8000 pages per month
Number of PostScript fonts136
Power consumption (standby)13 W
Power consumption (PowerSave)130 W
Export Control Classification Number (ECCN)EAR99
Weight and Dimensions IconWeight and Dimensions
Depth478 mm
Width399 mm
Height383 mm
Package width515.61 mm
Package height584.19 mm
Package weight21201.2 g
Dimensions (WxDxH)399 x 462 x 383 mm

Related product manuals