30 Installing and Configuring the PostScript Driver on Linux
Before Installing the Print Driver
Check the following contents before installing the print driver.
Environments Confirmed for Operation
Environments that are confirmed for the operations of the Linux print driver are as
follows. This print driver uses CUPS (Common UNIX Printing System) as the
printing system.
Distribution and CUPS Version (*1)
• RedHat Enterprise Linux WS Version 4 : CUPS Version 1.1.22rc1
• Turbolinux 10 F.: CUPS Version 1.1.19
• Turbolinux FUJI.: CUPS Version 1.1.23
• SUSE Linux 9.3 Professional : CUPS Version 1.1.23
• SUSE Linux 10.1 : CUPS Version 1.1.23
NOTE: (*1): For details on the newest operating environment, refer to readme.txt.
Hardware Environment
•PC
A personal computer installed with a x86-compatible, 32-bit CPU and operated
by various distributions
• Memory capacity
Compliant with the specifications recommended by the distribution (at least
512MB for Turbolinux, and 256 MB for RedHat Enterprise Linux)
Interface
• Parallel
• USB (*2)
• Ethernet (supported protocol: LPR (TCP/IP))
NOTE: (*2): The USB interface must be equipped as the standard. (However, this does not
include the warranty of all operations of devices supporting USB.)
Checking the Network Environment
Check the following settings before installing the print driver when using the device
in a network environment (LPR protocol) connected by Ethernet:
• The device settings can be checked by printing the Functions Setting List.
• For details on the Functions Setting List, refer to the manual that comes with the
device.
• For details on the way to configure the computer, refer to the manual that comes
with the computer.
At the computer At the device
Settings for IP address, and for using TCP/IP
environment are configured.
• IP address is set
• LPD protocol is enabled (Factory default:
Enable)
To Next Page
Loading...
Need help?
General