52 Using PCL Emulation
Switching Languages by Commands
If the printer receives a command that explicitly tells which language to use, the
printer switches to that language.
Switching Languages Automatically
The printer examines data received by its host interface and automatically
determines and switches to the appropriate language.
Switching Languages by Interface
The printer can be programmed to switch to a particular language for a particular
host interface. This can be done by setting a language for each interface on the
control panel.
Mode Menu Screen
The menu items for the emulation modes can be accessed from the mode menus.
To access the mode menu for the PCL emulation mode, press the <Menu> button
and select [Print Language] > [PCL]. The following is the first screen of the PCL
mode menu.
Reference: For more information about the setting items of the PCL mode menu,
refer to "5 Setting the PCL Mode" (P. 55).
About Fonts
This section explains the fonts that can be used in the PCL emulation mode.
Supported Fonts
The following fonts can be used in the PCL emulation mode.
NOTE: The PCL 5 fonts can be used also by downloading it on the hard disk (optional).
The supported fonts and their print samples can be viewed on the [PCL Font List]. For
information about the PCL 5 fonts, refer to the section [PCL Font List] in the User Guide.
To Next Page
Loading...
Need help?
General