Setting the ESC/P Mode 71
Setting the ESC/P Mode Menu
This section explains the items in the ESC/P mode menu and how to configure
them.
ESC/P Mode Menu Items
The items that can be set in the ESC/P mode menu are as follows:
Features Menu
Paper Tray
Sets the paper tray to be used when printing.
The following options are available:
[Tray 1] (Bypass Tray)
[Tray 2] (default)
[Tray 3]
[Tray 4]
[Tray 5]
[Auto]
When [Auto] is selected, the printer searches for the paper tray that contains the
paper that matches the [Output Size] setting and automatically feeds paper from
that paper tray.
NOTE: [Tray 2] - [Tray 5] display the size of the paper loaded in each tray next to the tray
names.
When [Auto] is selected, and if the paper of the same size is loaded in more than one
paper tray, the printer selects a paper tray based on the tray priority setting of a common
menu.
[Tray 3] - [Tray 5] are displayed only if the 550 sheet feeders (optional) are installed.
Output Size
Sets the size of the paper to be used when printing. This can be set only when
[Paper Tray] is set to [Auto] or [Tray 1] (Bypass Tray). Only the sizes for cut sheets
can be selected.
The following options are available:
[A4] (default)
[A3]
[A5]
[B4]
[B5]
[11 x 17]
[8.5 x 13] (Available only when [Paper Tray] is set to [Tray 1] (Bypass Tray))
[8.5 x 14]
[8.5 x 11]
[100 x 148mm] (Available only when [Paper Tray] is set to [Tray 1] (Bypass Tray))
To Next Page
Loading...
Need help?
General