Поиск и устр. неиспр.
136 Phaser 6700 Color Printer
Руководство пользователя
Solving Print Quality Problems
В этом разделе рассматриваются следующие вопросы.
Use the following table to find specific solutions to print-quality problems:
Problem Solution
Smears, Smudges & Streaks
Dark or light marks appear on your
output.
1. Run the Fuser Cleaning procedure: At the control panel, select Printer
> Tools > Troubleshooting > Resolve Problems > Smears, Smudges
& Streaks, then run the cleaning procedure. Several blank pages feed
through the printer to remove toner accumulated on the fuser.
2. If the problem persists, print the Test Pages to help determine which
component is causing the image quality problem.
• If the defect occurs only in one color, replace the corresponding
imaging unit.
• If the defect occurs in all colors and is visible on all the Test Pages,
replace the fuser.
Repeating Spots or Lines
Spot or lines appear at regular intervals
on the prints.
To identify the source of repeating defects:
1. Print the Repeating Defect Page to identify the part of the printer
causing the problem: At the control panel, select Printer > Tools >
Troubleshooting > Resolve Problems > Repeating Spots or Lines, then
print the page.
2. A page prints with instructions on how to identify the part
responsible for the repeating spots or lines.
3. Replace the printer part identified by the Repeating Defects Page to
correct the problem.
Примечание. Select the video menu to view a detailed
video for identifying the part causing the repeating defect.
Colors Look Wrong
Colors are off or look drastically wrong.
1. Verify that the printer is on a solid, level, and flat surface.
2. Perform the Color Registration procedure: At the control panel,
select Printer > Tools > Troubleshooting > Resolve Problems >
Colors Align Incorrectly, then perform the Register Color procedure.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
