DP-7022P Users Manual
3
2. Operation Guide
Please read the following suggestion carefully before you install the driver.
2-1. Safety
The driver is authorized to be installed and operated by the professional staff.
Don’t turn on the power before connecting to the motor.
Make sure that the input signal meets the technical requirements.
Don’t make the setting or measure operations on the motor and driver during
power on.
Please do the wiring, installation and parameter setting after power is off for more
than 3 minutes.
Ensure the connection operation is absolutely correct and fixable before you turn
on the power, including the power wire, motor cable and signal cable.
Avoid electromagnetic interference.
2-2. Attention
Please use shield cable for signal input, and leave each other for distance. The
further the distance, the better the interference is avoided.
Please connect the motor cover to the GND terminal.
Don’t operate the output terminal when power on, otherwise the driver will be
damaged.
2-3. Installation
Don’t install the driver next to the heat source.
Don’t expose the driver to the dusty, corrosive gas, moist environment, and work
in low vibration place.
For perfect conducting, please ensure the fixation between earth wire of host
computer, driver, motor and ground.
To Next Page
Loading...
Need help?
General