38
Using the CAM function
1. Press the [F ], and then touch [CAM
]
.
•
If [CAM] is not displayed, touch [FWD
] to display
[CAM] and then touch it.
•
The CAM screen is displayed, and the signal strength
of the channel that received the signal is displayed as
a bar graph.
Touch the bar graph to switch the frequency
1. Touch the bar graph on the screen.
•
The touched bar graph is displayed in orange and
switched to the memory channel frequency and received.
•
Press the PTT switch to transmit as it is, so you can
start communicating with the other station immediately.
YAESU
Change the displayed CAM group
1. Touch [GROUP] on the CAM screen.
YAESU
2. Touch the group to select the CAM group (GROUP 01
to 05) to be displayed.
The same operation as above is possible by rotating
the DIAL knob to select the CAM group, then press the
[BACK] key.
2 GROUP 02
3 GROUP 03
4 GROUP 04
1 GROUP 01
To Next Page
Need help?
General
