Yaesu FT-2DR User Manual

FT2DR/DE Technical Supplement
Alignment
ALIGNMENT-10
FM S-Meter Full-Scale Adjustment (S9 LEVEL)

Connect the test equipment as shown in Figure 2:
RX Alignment Setup.

Rotate the
DIAL
knob to select the Alignment
Menu "S9 LEVEL".

Set the RF Signal Generator output to 435.100
MHz, at a level of +20 dBμ, ±3.5 kHz deviation
with a 1 kHz audio tone.

Press the
[
V/M
]
button (the "Data" will appear
on the display).

Press the
[
X
]
key two times to store the FM
S-Meter Full Scale level.

Press the
[
V/M
]
button (the "Data" will disap-
pear on the display).
B-Band 144 MHz Band Adjustment
NOTICE: Do not touch the following Alignment
Menus in B-Band 144 MHz Band Adjustment:
"PLL REF"
"HI POWER"
"L3 POWER"
"L2 POWER"
"L1 POWER"
"MAX DEV"
"TONE DEV"
"DCS DEV"
Press the
[
BAND
]
key to select the 144 MHz Ama-
teur band.
Note: When the transceiver recalls Alignment
Menu "PLL REF", the
[
A/B
]
and
[
BAND
]
key oper-
ation is ignored. In this case, rotate the
DIAL
knob
to select an Alignment Menu other than "PLL REF".
Receiver Sensitivity Adjustment (TUNE DEV)

Connect the test equipment as shown in Figure 2:
RX Alignment Setup.

Rotate the
DIAL
knob to select the Alignment
Menu "TUNE DEV".

Set the RF Signal Generator output to 145.100
MHz, at a level of -10 dBμ, ±3.5 kHz deviation
with a 1 kHz audio tone.

Press the
[
V/M
]
button (the "Data" will appear
on the display).

Rotate the
DIAL
knob for maximum deection
on the SINAD meter.

Press the
[
V/M
]
button (the "Data" will disap-
pear on the display).
Squelch Hysteresis Conrmation (HIS SQL)

Rotate the
DIAL
knob to select the Alignment
Menu "HIS SQL".

Conrm that the alignment value is "0".

Yaesu FT-2DR Specifications

General

Brand	Yaesu
Model	FT-2DR
Category	Transceiver
Language	English