FTA-250L OperATing MAnuAL6
Before You Begin
Antenna Installation
Grasp the base of the antenna
firmly, and exert a moderate
“pinching” pressure on the base
while pressing the antenna onto the
transceiver antenna connector.
When installing the supplied
antenna, never hold the upper
part of the antenna while
screwing it onto the mating
connector on the transceiver.
Never transmit without having
an antenna connected.
Belt Clip Installation
Attach the belt clip on the back of transceiver using the
supplied screws
(
two
)
.
Installing the Battery Pack
1. Insert the battery
pack into the battery
compartment on
the back of the
transceiver
2. Push the battery in
until the battery latch
on the lower back side of the transceiver clicks
securely
Caution
There is risk of explosion if the battery is replaced with an
incorrect type.
Dispose of used batteries according to the instructions.
Removing the Battery Pack
1. While sliding the latch
in the direction of the
arrow, as shown in the
illustration, slide the
battery pack downward
and out of the transceiver.
To Next Page
Loading...
Need help?
General
