116 RM1x SEQUENCE REMIXER
SONG MODE
1. SONG Playback
Time signature
Track number
Song name
Track status
Transpose
Measure
1. SONG Playback
Parameter Values Function
Song number / name U01 ... U20 Selects the song.
Jump OFF, 001 ... Specifies the measure the RM1x will “jump” to when the STOP s
button is pressed. When “OFF” the playback locations remains where
it is when playback is stopped.
Keypad velocity 001 ... 127, RND1 ... RND4 Specifies the note velocity value for the RM1x keyboard. Higher val-
ues produce louder sound.
BPM 25 ... 300 Sets tempo for song playback.
Track number 01 ... 16, BPM Shows the current selected track number. Track number selection
can be accomplished via this parameter, or by the keyboard method
described on page 27.
Transpose -36 ... +36 Shows the current transpose value. Transposition can be accom-
plished via this parameter, or by the keyboard method described on
page 27.
Measure Sets playback start location; or shows current playback location.
Time Signature 1/16 ... 16/16; 1/8 ... Sets the song’s time signature.
16/8; 1/4 ... 8/4
Track status M, S Indicates track SOLO or track MUTE.
The highlighted track number indicates the currently selected track.
To select and play a song
1 Make sure the SONG mode is selected (if neces-
sary, press the MODE [SONG] button). “SONG”
should appear in the upper left-hand corner of the
LCD display.
2 Use Display Knob 1 to select a song (01 … 20).
3 Press PLAY p to start playback.
The PLAY p button indicator will flash at the cur-
rent BPM rate, the velocity bars above active tracks
will indicate playback level in the corresponding tracks,
and the MEAS parameter will indicate the current
measure during playback.
4 Select tracks via the keyboard as described on page
27, and use the realtime controller knobs to change
parameters as required during playback.
In the SONG mode playback will stop automatically
when the end of the song is reached.
5 Press STOP s if you want to stop playback before
the end of the song.
* For information about how to change values, refer to the Basic Operation (page26).
To Next Page
Loading...
Need help?
General
