52 RM1x SEQUENCE REMIXER
PATTERN MODE
2. Recording
❏ Step Recording
You use this recording mode to create a recording one note at a time, setting appropriate values for each note’s length, velocity,
and so on.
When EVENT TYPE = Note:
Track number
Event type
Time signature
Pointer
When EVENT TYPE = PB:
Track number
Event type
Time signature
Pointer
When EVENT TYPE = CC:
Track number
Event type
Time signature
Pointer
Parameter Values Function
Pointer Current note position.
Step The “size” of the current recording step. This determines to what
position the pointer will advance after a note has been entered.
Keypad velocity 001 ... 127, RND1 ... 4 The velocity value of the note to be entered
Value
Specifies the value for event types other than “Note.” This parameter
only appears when an EVENT TYPE other than “Note” is selected.
Press the [ENTER] button to actually enter the specified value.
Gate time 001 ... 200 The length of the entered note. Used to produce legato, staccato,
and other effects.
Rest
Enters a rest of the currently selected note length at the note pointer position.
Tie Lengthens the previously entered note by “tying” another note of
the same length and pitch to it.
Delete Deletes the note or chord at the note pointer.
BkDelete Moves the note pointer backward by the currently selected note
length and deletes the corresponding note or chord.
Track number 01 ... 16 Shows the current selected track number. Track number selection
can be accomplished via this parameter, or by the keyboard method
described on page 27.
Event type Note, PB, CC[000] ... CC[119] Specifies the type of event to be entered.
Time Signature
1/16 ... 16/16; 1/8 ... 16/8; 1/4 ... 8/4
Indicates the pattern’s time signature.
-8192 ... +8191 (EVENT TYPE=PB),
000 ... 127 (EVENT TYPE=CC), PAD
0060, 0080, 0120, 0160, 0240,
0320, 0480, 0960, 1920
* For information about how to change values, refer to the Basic Operation (page26).
To Next Page
Loading...
Need help?
General
